Barry-Wehmiller Streamfeeder Value Series Manual page 21

STEP 2:
Side Guides Setting
V S V-710iJ M
alue erieS anual
Dual-Knob Side Guides. To adjust each side guide for proper offset
horizontal spacing using the dual-knob adjustment, follow these steps:
1. Start by loosening each side guide wing adjuster (counter-clock-
wise) This will allow you to move each side guide as needed.
2. Grasp whichever side you wish to offset first and move into posi-
tion.
3. Place a small stack of material in the hopper, with edge of paper
against offset guide.
4. Move the second side guide so that it is located at the recom-
mended distance from the material: .0625 in. (1.6 mm) from each
edge, .125 in. (3.1 mm) overall.
5. Tighten each wing adjuster after you establish proper position for
each guide.
6. Visually check both guides for proper spacing from material.
15