Table of Contents
Advertisement
STEP 3:
Raising Hopping Rollers
NO TE
If additional control of material is required
during feeding, you may choose to keep the base's
hopping roller assembly in the down (or normal)
position.
STEP 4:
Disabling the Shuttle
!
!
To prevent any accidental startup of shuttle
motor and to eliminate the hazard of moving
parts, you can prevent accidental startup by
either disconnecting vacuum base from AC
power at the outlet, or you can remove the
internal AC power fuse (located behind the
access door of the vacuum base).
V
S
V-710iJ M
alue
erieS
anual
1. Locate the gate adjustment knobs (Figure 2-3) and turn com-
pletely in a clockwise direction to raise hopping rollers.
2. Then, locate the vertical adjustment lever on the hopping roll-
ers assembly and push down all the way. This will raise the
feed rollers to highest vertical position possible, thus making
for maximum clearance.
Figure 2-3.
Using the Adjustments to Raise Hopping Rollers
1. Remove side access panel from vacuum base enclosure.
2. Locate the reciprocating arm and reciprocating block directly
beneath the underside of shuttle (Figure 2-4).
3. Using a box wrench, remove the hex-head rod end bearing
bolt holding the reciprocating arm to the reciprocating block.
4. Once the bearing bolt is removed, the reciprocating arm is ef-
fectively disconnected. As the shaft is connected to the shuttle
base plate on the other end, simply allow the shaft to hang
in-position, with no further disassembly.
5. Make sure the base plate of shuttle is all the way forward
(toward the vacuum base gate).
Hex-head
Reciprocating
rod end
arm
bearing bolt
Figure 2-4.
Disabling the Shuttle from Inside the Access Panel
Vertical adjustment
lever
Gate adjustment
knob
Reciprocating
block
7
Advertisement
Table of Contents
