Barry-Wehmiller Streamfeeder Value Series Manual page 14

STEP 5:
Initial Positioning
of Feeder
STEP 6:
Providing AC Power
to Feeder
IMPOR TANT
Please verify that the voltage shown at the power
inlet module matches the incoming voltage from
the power source.
In order to comply with EN 6100-4-5, the AC
power line must be protected with a surge
suppressor.
8
1. Lift the feeder onto the top plate of the vacuum base and slide
forward toward the vacuum base gate.
2. Center the feeder between the two side guides as you posi-
tion the feeder fully forward. To verify centering, sight down
the center of the feeder gate, making sure it is in-line with the
vacuum base gate (Figure 2-5).
3. Trap the feeder in-between the vacuum base side guides by
sliding each in toward the side plates of the feeder until they
gently touch. Tighten side guide knobs to secure in position.
Figure 2-5. Positioning the Feeder on the Vacuum Base
1. Connect IEC320 end of power cord to the feeder (at the power
inlet module).
2. Connect three-prong end to nearest AC voltage power source.
Center
V S
alue erieS
V-710iJ M
anual