Table of Contents
Advertisement
Table 1-2. Control Panel Feature Descriptions
Feature
External run input connector
(optional)
Power On/Off
Fuse holder
AC power cordset connector
Mode switch (optional)
Variable speed control
Run delay
4
Description
This 4-pin connector (labeled External Run Input) is used to carry start/
stop signals from a vacuum or non-vacuum base to the feeder.
Toggles AC power On or Off.
Contains two replaceable 5-Amp, 5x20 mm time delay fuses.
IMPORTANT: Always make sure power module is replaced exactly as
removed so that "115" is always visible on 115V models and "230" is
always visible on 230V models. Failure to follow this caution can result in
damaged electrical parts.
Cordset plugs into this IEC320 connector to provide feeder with power
from a grounded and fused outlet.
Note: Included with optional external run input only. This slide switch
(labeled Continuous/External Run) allows you to use the feeder "stand-
alone" or with the optional external run input interface.
This dial switch (labeled Speed) allows the feeder speed to be
synchronized with a vacuum or non-vacuum base. Turning counter-
clockwise decreases speed; clockwise increases speed. Note: Feeder
motor stops if turned completely counter-clockwise.
Used to delay (or synchronize) feeder startup with base startup. Range is
adjustable from 0 to 12 seconds.
V
S
V-710iJ M
alue
erieS
anual
Advertisement
Table of Contents
