Table of Contents
Advertisement
Physical Layer Options (PHYS LYR OPTS)
Interface Type (INTERFACE)
Select the connector type for the
EIA-232 and V.35.
Bit Rate
Select the operating speed of the DTE interface.
The bit rate selections vary depending on the speed selections made for the
network port. Also, for rates higher than 56/64 kbps, the External DCE
card is required.
TD Clock Source (TD CLOCK SRC)
Set clock source to I
Transmit Idle Code (TX IDLE CODE)
Enable the Express 5210 to transmit F
Hardware Flow Control
When set to O
temporarily limit the transmit data rate from the DTE device to the
Express 5210.
PPP Async Protocol
The PPP A
S
YNCHRONOUS
connected to an async device. Special control characters are used to
determine frame boundaries for the async channel. See Figure 7-9
for the PPP A
Routing
Routing tables are formed through a combination of RIP and static
route entries. If RIP is used, all routing tables are generated
dynamically. With static routing, the user is able to force
relationships. Static routing requires additional configuration (see
the chapter IP Setup on page 12-1 for more information).
61200208L1-1
DTE
or E
NTERNAL
XTERNAL
, the Express 5210 varies the transmit clock rate to
N
protocol functions the same as the PPP
SYNC
protocol except the port is in async format,
menu tree.
SYNCHRONOUS
Express 5210 User Manual
Chapter 7. DTE Port Configuration
interface. The choices are
.
or all O
.
LAGS
NES
7-17
Advertisement
Table of Contents
