Table of Contents
Advertisement
Selections Available for a Unit in Direct Mode
The DLCI M
DLCI used for voice traffic. This information must be configured in
both the local and remote units. Voice data may be multiplexed
with data on the same DLCI.
Line 1 DLCI (L1 DLCI)
Enter the local DLCI that line 1 voice data is to be carried on.
Line 2 DLCI (L2 DLCI)
Enter the local DLCI that line 2 voice data is to be carried on.
Selections Available for a Host Unit in Switched Mode
The DLCI M
access to the remote extension table that is maintained by the H
unit. The table consists of a local DLCI associated with the voice
data on a remote Express 5210 and the extension for the two voice
ports connected to that DLCI. The Express 5210 supports up to 20
DLCIs which yield a total of 40 voice ports. On the front panel,
Next
DLCI/Extension information is communicated to the remote units
over the network; therefore configuration is not required on the
remote units.
Ext 1
Enter the extension for line 1 on a remote Express 5210.
Ext 2
Enter the extension for line 2 on a remote Express 5210.
DLCI
Local DLCI that carries E
Cascade Entry (CASCADE)
Set to Y
units, connect via the
to Y
the host's DLCI field (described previously).
61200208L1-1
choices for a unit in D
APPING
choices for a H
APPING
,
,
, and
Previous
Add
Delete
XT
when cascading units from the host unit. To cascade
ES
DTE
and enter the DLCI number connecting the two units into
ES
Express 5210 User Manual
Chapter 8. Voice Configuration
M
IRECT
unit in S
OST
WITCHED
keys are used to edit this table. The
1 and 2 data.
port. Set the host unit's C
specify the
ODE
M
give
ODE
OST
E
ASCADE
NTRY
8-3
Advertisement
Table of Contents
