Interfaces - ADTRAN Express 5210 User Manual

Option Description
Gateway Displays the IP address of the host or router receiving forwarded pack-
ets.
Interface Displays the interface to which IP packets with this address will be rout-
ed.
L : Sent directly to the Express 5210 router
OCAL
EN0: IP Express 5210 ethernet port
E
NDPOINT
Used Displays the usage count of this routing table entry.
Clr Select to clear the U
Flags Indicates the properties of this routing table entry, composed of the fol-
lowing letters:
H - route is a host route
G - route is a gateway route
D - route learned dynamically from RIP
I - route learned from an ICMP redirect
P - route is private and is not advertised with RIP
T - route is to a triggered port (updated only when table changes)
Hops Displays the number of router hops required to get to the network or host.
Ranges from 0 to 16. If set to 16, it is defined as infinite and cannot be
routed.
TTL Time to live. Displays the number of seconds until the address is re-
moved from table. Value of 999 means the route is static.

Interfaces

The I
connected to the Express 5210. See the following chart for
descriptions of each field.
Option Description
Network Name Displays the name of the interface connected to the Express 5210
router. See the section Network Name Entries on page 12-9 for an
explanation of how names in this field are acquired. Possible en-
tries are listed below:
EN0 IP: Express 5210 ethernet port
E
NDPOINT
61200208L1-1
N : (DLCI #)
AME
count.
SED
menu configures and monitors all interfaces
NTERFACES
N : (DLCI #)
AME
Express 5210 User Manual
Chapter 12. IP Setup
12-7