Table of Contents
Advertisement
Mounting the Sensor PCB Assembly
1. Attach the longer spring to the white resin, and attach the
shorter spring temporarily to the sensor assembly bracket.
2. Mount the sensor assembly so that the shaft of the lift arm is
inserted into the longer hole on the white resin located on the
back of the sensor PCB assembly.
3. Attach the shorter spring to the hook of the lift arm.
Mounting the Main PC Board Assembly
1. Rotate the third gear clockwise until section (E) of the front
slider and the third hole from the right are lined up.
(Be sure to set properly. If incorrectly set, the switches on the
PCB assembly may be damaged.)
2. After they are correctly positioned, mount the main PCB
assembly.
1‑16
Attach
temporarily
Shorter
Longer
spring
spring
Position so that the slider hole and third hole
Sensor assembly fixing screws
Fig. 47
from the right are lined up
Fig. 48
Shorter
spring
(E)
Advertisement
Table of Contents
