Table of Contents
Advertisement
Precautions On Reassembling
When reassembling, also refer to the
disassembling procedures.
Mounting the Traverse Mechanism
1. When mounting the pickup assembly, attach the feed slide
shaft assembly to the traverse chassis.
Apply E-JC-525 grease to the shaft.
2. Mount the middle gear and the feed slide shaft to the traverse
chassis and secure them with the screw (14) through the
shaft holder.
3. Before mounting the mechanism PCB assembly, move the
pickup to the outer edge position, then secure the PCB
assembly using the screw (15).
At this time, check that the rest switch is correctly placed.
4. To mount the rack arm, first move the pickup to the middle
position and secure it with the screws (16).
Mechanism PCB Assembly
15
15
1‑11
Fig. 33
Pickup Assembly
Motor
Fig. 31
Feed Motor
Shaft Holder
15
Attached to chassis
14
Shaft Holder
Feed Slide Shaft (half
coated with grease)
Middle Gear
Chassis
Mounting the
Feed Motor Assembly
Spindle Motor
Fig. 32
16
Rack Arm
Move the pickup to the
middle position
Fig. 34
Advertisement
Table of Contents
