Table of Contents
Advertisement
Mounting the Front Slider and Rear Slider
1. Position the unit with the rear side facing down, then rotate
the third gear in the direction of the arrow (clockwise) until the
lift arm comes to the position at which the holes are exposed,
as shown in Fig. 45-1.
2. Mount the front slider from the top.
Rotate the third gear counterclockwise until the hole of the
slider is lined up with the right hole of the stud, as shown in
Fig. 45-2.
3. Mount the E-washer on the shaft.
4. Position the unit with the front side facing down, then mount
the rear slider. Check that the (r), (s) and (t) positions are
correctly mounted as shown in Fig. 46.
5. Rotate the third gear in the direction of the arrow
(counterclockwise) until the lifter unit is at the top position.
1‑15
Check after mounting
Rotate the third gear to
move the slider
Fig. 45-1
Front Slider
E-Washer
Set so the holes
are exposed
Rotate until the
holes are lined up
r
s
Fig. 46
Stud
Position so that the
stud and right hole
are lined up
Fig. 45-2
Fig. 45
t
Rotate the third
gear to move the
slider
Advertisement
Table of Contents
