Intercharacter Delay - Datalogic QuickScan I QD21 1 Series Product Reference Manual

Enter/Exit Programming Mode

Intercharacter Delay

This parameter specifies the intercharacter delay between the end of one char-
acter and the beginning of the next. The delay can be set within a range of zero
(0) to 990 milliseconds in 10ms increments. A setting of zero specifies no
delay. See
page 288 for more detailed programming instructions.
Select Intercharacter Delay Setting
Make a mistake? Scan the CANCEL bar code to abort and not
save the entry string. You can then start again at the begin-
36
"Intercharacter Delay"
$CR2IC
ning.
00 = No Intercharacter Delay
DEFAULT
on page 280 or "Intercharacter Delay"
$CR2IC00
Intercharacter Delay = No Delay
CANCEL
QuickScan™ I QD21X1 / QM21X1 / QBT21X1
Intercharacter Delay
on

~