Installing The Oven Accessories - Electrolux EVE626 User Manual

INSTALLING THE OVEN
ACCESSORIES
Slides (Telescopic runners)
1. Obtain left hand side rack and left hand slide – see
image to identify.
2. The shaded wires indicate the wire the slide can be
mounted on. Fit slide rear clips to the rear of wire at
1
an angle as shown below.
1
1
3. Push slide front clip over wire until secured
CLICK !
CLICK !
CLICK !
Side racks
1. Insert the rear peg into the rear access hole provided,
ensuring peg is fully inserted.
2. Then locate the front peg into the front access hole
and push in firmly.
2
2
3
2
3
3
NOTE: If you have purchased a two cavity appliance you
will have additional side racks for the lower oven/grill. These
are fitted in a similar manner.
Shelves
The shelves are designed so that they have maximum
extension but cannot be accidentally pulled right out.
To fit a shelf to side racks:
NOTE: To Locate the rear edge of the shelves, the detents
on the side wires should be towards the oven back wall.
See image.
1. Rest the rear edge of the shelf on the lower guide rail
of the side rack - see diagram. Ensure the same rail
positions on both sides of the oven are being engaged.
2. With the front edge raised, begin to slide the shelf in
between the guide rails of the side rack.
3. Once the detents have passed the front edge of the
side rack, the shelf can be pushed fully in.
4. When fully inserted the shelf should not interfere with
the closed oven door.
To fit a shelf or tray to telescopic slides:
1. Push the shelf or tray along the top of the slide until it
hits the back post.
2. Drop the front of the shelf or tray onto the slide
ensuring it sits behind the front post of the slide.
3. When fully inserted the shelf/tray should not interfere
with the closed oven door.
7
Detent
Back post
Back post
Front post
Front post