Installing Your Oven Accessories - Electrolux CVE614 User Manual

before operating your
appliance for the first time

Installing your oven accessories

The type of oven accessories you receive is dependant on
the model you have purchased.
1. Shelves and trays
caution
WARNING
Ensure the shelves are inserted in the correct orientation,
otherwise you may damage the appliance.
Your oven comes with formed "easy clean" shelf supports.
The shelves are designed to travel freely on the shelf supports
without being pulled out accidentally. Make sure you have
the shelf in the correct orientation before you slide it in.
Otherwise it could become jammed.
• Locate the rear edge of the shelf in the recess between
2 formed shelf supports. See diagram below.
NOTE: The top 'ledge' is not a shelf position.
note the orientation of the
side and rear features
• With the front edge raised, begin to slide the shelf into the
oven. Lower the front edge as you push the shelf fully in.
• The grill/baking tray for underbench oven models sits into
a wire carrier that fits into the oven exactly like the shelves.
• The grill/baking tray for separate grill wall oven models
slides into the wire runners in a similar manner.
• When fully inserted, the shelf/tray should not interfere
with the closed oven door.
2. Main oven wire side racks (where applicable)
The side racks that come with your oven can be attached
to either side of your oven.
• Insert the twin pegged side into the rear access holes
provided, ensuring that the pegs are fully inserted.
• Then locate the front peg into the front access hole
and push in firmly.
6 BEFORE OPERATING YOUR APPLIANCE Built-in Cooking
• When locating the left side rack into the small oven or
grill, ensure the pegs are inserted into the upper two
access holes.
3. Separate grill side racks (where applicable)
Separate grill wall ovens come with side racks that are to
be fitted to the smaller lower grill/oven.
These can be attached to either side in the following manner:
• Insert the largest peg into rear access hole provided.
See diagram above.
• Then locate the front peg into the front access hole and
push in firmly.
• When locating the left side rack into the small oven or
grill, ensure the pegs are inserted into the upper two
access holes.