Electrolux EVE626 User Manual page 6

6 electrolux.com.au
IMPORTANT INSTRUCTIONS
Levelling oven
Place a level in the oven as below making sure the level sits
on the front and rear forms. The level needs to be correct
to prevent slides from moving in or out with gravity.
Underbench oven
Your underbench oven looks best when the control panel
is directly under the benchtop. An upper infill panel may
be added if the cooktop placed above the benchtop is too
deep. Refer to cooktop installation instructions for required
clearance between cooktop and oven.
IMPORTANT!
Note: Dimension'D'*
A requirement for all EVEPxxxx pyrolytic clean
ovens and all Duo ovens – for proper ventilation
there MUST be a gap at the bottom rear of the
cabinet. This can be a full width opening 20mm
deep. Refer to dimension "D" in relevant diagram.
Power point connection for the EVEP618 must be
accessible with the appliance fully installed. If the supply
cord is damaged it must be replaced by the manufacturer,
its service agent or similarly qualified persons in order to
avoid a hazard.
Cut-out dimensions
type of fit A (width)
Flush fit (mm) 600
Proud fit (mm) 568
✓
B (height) C (depth)
600 581 min.
590 560 min.
561mm
mounting
holes
582mm.
Fit black
596mm
screws
provided.
(CONTINUED)
Double oven Cut-out dimensions
type of fit A (width)
Flush fit (mm) 600
Proud fit (mm) 568
650mm
min.
Pyrolytic underbench Cut-out dimensions
type of fit A (width) B (height)
Flush fit (mm) 600
Duo oven Cut-out dimensions
type of fit A (width) B (height)
Flush fit (mm) 600
D D
650mm
min.
B (height) C (depth)
1086 581 min.
1078 560 min.
561mm
596mm
mounting holes
582mm. Fit
black screws
provided with
plastic spacers
provided
C (depth) D*
600 581 min. 20
561mm
596mm
C (depth) D*
893 581 min. 20
561mm
mounting holes
582mm.
Fit black screws
provided
mounting holes. Fit
black screws with plastic
spacers provided
mounting
holes
582mm.
Fit black
screws
provided
mounting
holes
582mm. Fit
black screws
provided