Ethernet network may not function correctly. Step 1: Connect the LRA-900-E to the same hub or the same sub-network as your Host PC, and attach a power supply to the LRA-900-E. Do not connect the LRA-900-E to a router or directly to the Internet as this may cause the update process to fail.
2.1.1. Local Firmware Update Step 1: In the eSearch Utility, click the “Search Server” button to search for any LRA-900-E modules connected to the network. (The network settings of the LRA-900-E module as described in Step 3 on Chapter1) Step 2:...
Page 6
IP Address (can be different with the current IP) and the factory-default MAC Address for the LRA-900-E module. If this IP addressis invalid (e.g. IP Address: 0.0.0.0) or a user-defined MAC address is assigned. Refer to note2(Page 20) note 3(Page21) for more details.
Page 7
“Run Mode”. Step 13: In the eSearch Utility, search for the LRA-900-E module again to verify that it is functioning correctly. Note that the network settings for the module may need to be reconfigured after updating the firmware. Refer to...
Note that all firmware update procedures need to be carried out on the remote system. Follow the procedure described below to update firmware of the LRA-900-E on the remote PC: Step 1: In the eSearch Utility, click the “Search Server”...
Page 10
IP Address (canbe different with the current IP) and the factory-default MAC Address for the LRA-900-E module. If this IP addressis invalid (e.g. IP Address: 0.0.0.0) or a user-defined MAC address is assigned. Refer to note2(Page 20) note 3(Page21) for more details.
Page 11
Step 8: Open a web browser such as Internet Explorer or Firefox and enter the URL for the LRA-900-E in the address bar of the browser and log in to the web configuration pages (use the default password “admin”). Step 9: Click the “Network Setting”...
Page 12
Once the update is complete (i.e., when the progess indicator reaches 100%), close the Command Prompt window. Step 13: In the eSearch Utility, search for the LRA-900-E module again to verify that it is functioning correctly. Note that the network settings for the module may need to be reconfigured after updating the firmware.
IP address to LRA-900-E module. Follow the procedure described below: Step 1: Run the eSearch Utility to search for any LRA-900-E modules in the network Step2: Double click the name of LRA-900-E to open the “Configure Server (UDP)”...
Page 18
IP address to LRA-900-E module. Follow the procedure described below: Step 1: Run the eSearch Utility to search for any LRA-900-E modules in the network Step2: Double click the name of LRA-900-E to open the “Configure Server (UDP)”...
BOOTP mode, as described in Chapter 3, and the update should be successful. The LRA-900-E obtains the IP address assigned by the user and retrieves the firmware image through the utility program. Note that when updating the firmware, the LRA-900-E uses the factory-default MAC address rather than any user-defined MAC addresses.The LRA-900-E...
Page 21
BOOTP (Bootstrap Protocol) is defined in RFC-951 and uses UDP ports 67 and 68. Note6: TFTP (Trivial File Transfer Protocol) is defined in RFC-1350 and uses UDP port 69. LRA-900-E (Ethernet to LoRa Radio Modem) Firmware Update via Ethernet Version 1.0.0 Page:...