Table of Contents
Advertisement
3. Troubleshooting
3.1. Firmware update in BOOTP mode
If the module is not functioning correctly (e.g. there is no response to the search request, or if the
PWR/RF_Tx/RF_Rx LEDs
are
alway
displayed as either all off or all on),
please
download a new image of the firmware from the ICPDAS web site and
then update the
firmware for the module using the following procedure.
Step 1: In the eSearch Utility,
select the
"BOOTP"
item from
the
"Server"
menu. A check
mark should be displayed next
to the item after it has been
selected.
Step 2:
Set the
"Init Switch"
to the
"Init Mode"
position.
Step 3:
Power-on and reboot
the LRA-900-E module and then click the
"Search Server"
button to
search for the LRA-900-E at the same time.
Note, the module sends BOOTP messages
about 5 seconds when booting in Init Mode.
If this step is not successful, reboot the
module and execute the search again.
14
LRA-900-E (Ethernet to LoRa Radio Modem) Firmware Update via Ethernet
Version 1.0.0
Page：
Copyright © 2018 ICP DAS Co., Ltd. All Rights Reserved
E-mail: service@icpdas.com
Advertisement
Table of Contents
