Power Off Timing (Low Power Mode) - Honeywell N568X Integration Manual

Tx - Sending data from the host*
Note: * The following settings were used to capture the above plots: DEFALT;TERMID0;TRGLPT2;232LPT2;TRGMOD2.

Power Off Timing (Low Power Mode)*

After nWAKE and nTRIG are released it takes about 6 seconds for the PWRDWN signal to go high (hardware time-out)
with the lowest setting for TRGLPT (TRGLPT1 - low power time-out of 1 second). Below is a representation of the power off
sequence.
* The following settings were used to capture the above plots: DEFALT;TERMID0;TRGLPT1;TRGMOD2.
3 - 5