Table of Contents
Advertisement
Optics Module to Decoder Board Connector
The imager flex circuit is a custom component. There are two flex circuit options available; one for bracketed and non-bracketed
applications and a longer one for non-bracketed applications only. The flex coming across the decoder board and connecting to
the top of (not across) the engine is the recommended orientation. This orientation allows the pixel clock to sit between two
grounds, which helps with EMI. See
Decoder Board to Host Interface Connectors
The interface connector is a Molex 0.5mm vertical surface mount FFC/FPC connector (part number 52559-1252). See
Board Interface Connector
12-pinM FPC Connector (Gold)
The product is fitted with a 12-pin FPC connector located on the back of the unit for TTL232 or USB (full speed) communication,
optional power, and signaling.
Warning! Do not connect the flex strip to or disconnect the flex strip from the host interface connector when
power is present. This could damage the image engine.
Warning! When using the Micro-B connector (mentioned below), DO NOT apply power through the Flex
connector (Pin 2 - Vin). Doing so can cause harm to either the host or image engine.
1 - 2
Optics Module to Decoder Board Flex Circuit
on page 5-8 for details.
on page 5-8 for details.
Top
Bottom
Decoder
1
Advertisement
Table of Contents
