Adjustment Of Throttle Control Handle; Adjustment Of Clutch Handle - VOGE 500AC E5 User Manual

Adjustment of throttle control handle

·The throttle control handle is used to control the engine speed.
·Turning in the direction of oneself is acceleration, and vice versa is
deceleration.
·Adjustment of throttle cable clearance.
–Remove the rubber sleeve 1.
–Loosen lock nut 2.
– Rotate the regulator 3 to adjust the throttle cable clearance to
between 2-4mm.
–Lock nut 2.
–Reinstall the rubber sleeve 1.

Adjustment of clutch handle

·When starting the engine, braking or shifting gears, grip the clutch handle to
disengage the clutch friction plate, thus cutting off the engine transmission
power.
· The free travel of the end of the clutch handle should be between 5-8mm. If
it is not correct, please adjust it in accordance with the following methods.
– move glue set.
–Loosen lock nut 1.
–Rotate regulator 2 to ensure free travel between
5-8mm.
–Lock nut 1. – Reinstall the rubber sleeve.
· After the throttle cable clearance adjustment is completed, ensure the throttle control handle can
automatically return to position and idle speed won't increase.
·Turn the direction to the left and right limits respectively, and the idle speed shall not be increased.
32
Free stroke of clutch handle is too large, which is easy to cause
wear and failure of clutch and shift-gear mechanism.
!
Notice
1 3 2
The free clearance between
throttle cables:2-4mm.
The free stroke of the clutch
handle ends:5-8mm.
!
Warning
2 1