Table of Contents
Advertisement
Installation & Adjustment
Water inlet
1. Connect the cold hose (blue connector) to the cold
tap and the hot hose (red connector) to the hot tap.
You may have to use pliers to tighten the coupling.
Do not over tighten as this may cause damage to the
valve or hose fittings.
2. Connect the other end of the hose to the respective hot and
cold inlet valves, located at the rear of the washing machine.
3. We recommend replacing the inlet hoses every 5 years.
Hoses should be checked from time to time and replaced if any wear, damage
or leaks are found.
Connection between the water inlet hose and
the washer
1.Do not take off the water absorption cushion.
Please check if the cushion has dropped off
or is damaged before attaching to the
washing machine. If this happens please
contact our after-sale department
immediately.
2.Put the nut of the water inlet hose onto the
inlet valve thread.
3.Fasten the nut.
Check the inlet hose connections
1. Swing the hose gently to confiem that the hose is
securely fastened and can pivot as required
2. After installation, open the tap to check for leaks.
3. Do not bend the hose unduly.
4. Periodically check the hose connections are firm
at both ends. This is to ensure the connections
remain water tight over time.
nut of the water inlet hose
Water absorption cushion
Thread of the water inlet valve
6
Advertisement
Table of Contents
