Table of Contents
Advertisement
Safety precautions
If power cord or other parts of this machine become damaged or faulty, please
contact a
technician
may cause personal harm or void warranty.
The new hose-sets supplied with the appliance are to be used and the old hose-sets
should not be reused.
Please do not to remove the pump filter cap situated at the
bottom rear of the product in any situation as water remaining
in the product will flow directly out of the product.
In the event of a blockage or a failure to drain, please contact
the customer care centre for assistance.
The pump filter cap is only to be removed by a trained service
technician.
Installation & Adjustment
Please install and adjust the machine according to the directions contained in this
manual. It is very important to follow these directions for the safe operation of the
machine, and to ensure your machine operates correctly.
Installing the bottom plate
The purpose of the bottom plate is to suppress noise
from the washing machine during operation
Steps:
1. Tilt the machine backwards against a wall. (ensure
that the machine is well supported)
2. Place the plate onto the bottom of the machine.
3. Use a screwdriver to tighten the screw ( in accessory
bag) securing the panel to
4. Once the screw is tight and the panel
the washer to its standing position.
Note: The washing machine has ventilation openings in the base, the product must
not be placed on a carpeted surface.
to have it repaired .. Do not attempt repairs by yourself as this
.
the
bottom of the washer.
is
Pump filter cap
Screw
Bottom plate
secure, return
4
Front
Back
Carpet
Advertisement
Table of Contents
