Installation & Adjustment
1. Connect the cold hose (blue connector) to the cold
tap and the hot hose (red connector) to the hot tap.
You may have to use pliers to tighten the coupling.
Do not over tighten as this may cause damage to the
valve or hose fittings.
2. Connect the other end of the hose to the respective hot and
cold inlet valves, located at the rear of the washing machine.
3. We recommend replacing the inlet hoses every 5 years.
Hoses should be checked from time to time and replaced if any wear, damage
or leaks are found.
Connection between the water inlet hose and the
1.Do not take off the water absorption cushion.
Please check if the cushion is dropped
or damaged before each usage. If this
happens please contact our after-sale
2.Put the nut of the water inlet hose onto the
inlet valve thread.
3.Fasten the nut.
Check the inlet hose connections
securely fastened and can pivot as required
nut of the water inlet hose
Water absorption cushion
Thread of the water inlet valve