Troubleshooting - Stanley PBCC40 User Manual

The head pin won't fit through the hole in the cutting
head.
The tool won't cut when I press the trigger.
The InteLED flashes yellow when I activate the tool.
The tool repeatedly give me bad cuts / The InteLED
flashes red after every crimp.
The tool is leaking hydraulic oil.
10 ► PBCC40 User Manual

TROUBLESHOOTING

Problem Solution
Press and hold the pressure release. Ensure the
two halves of the cutting head are aligned. Close the
cutting head and insert the head pin.
Ensure the battery is charged. Disengage the trigger
lock.
The maintenance interval is about to elapse. Have the
tool serviced as soon as possible.
Ensure the battery is fully charged. Ensure the blades
are in good condition. If problem persists, have the tool
serviced as soon as possible.
Have the tool serviced immediately.