Technical Specifications - Omnitronic MCP-4600 User Manual

If the power supply cable of this device becomes damaged, it has to be replaced by a special power supply
cable available at your dealer.
Should you have further questions, please contact your dealer.

11. TECHNICAL SPECIFICATIONS

Power supply:
Power consumption (max.):
Power output sine:
8 Ohm:
4 Ohm:
8 Ohms bridged:
Frequency range:
Damping-factor:
Distortion factor:
Signal to Noise Ratio:
Min. input sensitivity:
Input impedance:
Input:
Output:
Control elements:
Low pass:
High pass:
Protection:
Indicators:
Construction:
Dimensions:
Minimum mounting depth:
Weight:
Please note: Every information is subject to change without prior notice. 12.09.2007 ©
230 V AC, 50 Hz ~
2100 W
4 x 400 W
4 x 600 W
4 x 1200 W
20 - 20 000 Hz
>150
0.05 %
95 dB
0.775 V
20 kOhms (balanced), 10 kOhms (unbalanced)
4 balanced XLR-connectors
4 balanced XLR-connectors, 4 x screw connectors
Power switch, Input attenuators (per channel), Low pass (two channels),
High pass (2 channels), Operating mode
50 - 250 Hz
50 - 250 Hz
Overheat, overload, short-circuit, DC, softstart, VHF signals
Power, Bridge, Protect, Clip, Signal
Steel chassis
482 x 490 x 90 mm
19"-dimensions with 2 u
510 mm
28 kg
32/32 00030074.DOC, Version 1_0