Installation - Omnitronic MCP-4600 User Manual

(8) FUSEHOLDER
Only replace the fuse when the device is disconnected from mains. Only use fuses of the same rating
and power. The correct fuse value is specified on the rear panel.
(9) AC-CONNECTION
Used to plug the power cord in.
(10)SPEAKER CONNECTIONS
Screw connectors for bridged mode.
(11)SPEAKER CONNECTIONS
Screw connectors for stereo mode.
CH3/CH4 HIGH
(12) HIGH-PASS FILTER ON/OFF
Switches the filter on and off.
(13) HIGH-PASS CONTROL
The high pass filter can be set from 50 to 250 Hz.
(14) XLR OUTPUT SOCKETS
Connect the output signals here using a balanced XLR-plug.
(15) XLR INPUT SOCKETS
Connect the input signals here using a balanced XLR-plug.
CH1/CH2 LOW
(16) LOW-PASS FILTER ON/OFF
Switches the filter on and off.
(17) LOW-PASS CONTROL
The low pass filter can be set from 50 to 250 Hz.
(18) XLR OUTPUT SOCKETS
Connect the output signals here using a balanced XLR-plug.
(19) XLR INPUT SOCKETS
Connect the input signals here using a balanced XLR-plug.
(20) STEREO/BRIDGE-SWITCH
For selecting the operating mode. In bridge mode, CH1 and CH2 or CH3 and CH4 are combined to
1200 W.
(21) AIR INTAKE OPENINGS

6. INSTALLATION

Please note: when using a PA-system in public or industrial areas, a series of safety instructions have to be
followed that this manual can only give in part. The operator must therefore inform himself on the current
safety instructions and consider them.
6.1 Rack installation
This amplifier is built for 19" racks (483 mm). The rack you use should be a Double-Door-Rack where you
can open the frontpanel and the rear panel. The rack should be provided with a cooling fan. When mounting
25/32 00030074.DOC, Version 1_0