Canon MV MVX2i Instruction Manual page 145

7. Select MIX LEVEL.
8. Adjust the mix level.
9. Close the menu.
• CARD MIX flashes in the display.
On/Off
10.Press the card MIX button.
• CARD MIX stops flashing.
• Your currently recording image is combined with the pre-recorded
animation.
• Each time you press the card MIX button, your selection is activated
(display lights continuously) or deactivated (display flashes).
Recording the Combined Image onto a Tape
For movies
1. Press the start/stop button to start and stop recording.
• The combined images are recorded onto the tape.
For still images
1. Press the PHOTO button halfway down and hold it.
• F flashes white in the display as the camcorder adjusts the focus and it
is displayed continuously as a green mark when the camcorder is ready
to take the image.
2. Press the PHOTO button fully down to record the image to
the tape.
• F disappears from the display.
• The combined images are recorded onto the tape for approximately 6
seconds.
Note:
• If you change the position of the POWER switch or TAPE/CARD switch,
select your still image for Card Mix again.
E
145