Canon MV MVX2i Instruction Manual page 101

Notes:
• When you add sound using the built-in microphone make sure not to
connect any cables to the MIC terminal.
• To use your TV to monitor video, connect the S-video terminal (
the AV terminal (use only the video plug) to your TV. You can monitor the
sound with headphones only when using the S-video terminal (
Preparations
Turn the camcorder's POWER switch to PLAY (VCR) and move the
camcorder's TAPE/CARD switch to TAPE. Load a recorded cassette.
• Make sure the REC/SAVE tab on the cassette has been slid to REC (closed
position).
Dubbing
Do not connect/disconnect any cables to/from the camcorder when dubbing
audio or preparing to dub audio.
PLAY
+
TAPE
(VCR)
VCR SET UP
( 38)
1. Open the menu and select VCR SET UP.
2. Select AUDIO DUB.
3. Select AUDIO IN or MIC. IN and close the menu.
4. Locate the point where you wish to start audio dubbing,
then press the PAUSE button.
• You can use the playback buttons on the body of the camcorder or the
special playback functions on the wireless controller in the same way as
in playback mode.
• The camcorder becomes set to playback pause mode.
REC
PAUSE
ZERO SET
MEMORY
/ /
AUDIO DUB.
AV INSERT
AUDIO DUB.••AUDIO IN
35) or
33).
REW PLAY FF
STOP + /
– /
× 2
PAUSE SLOW
AV DV MENU SET
E
101