Advertisement

Quick Links

Installation and Operating manual
UK
UK
®
BWT PERMAQ
COMPACT 111-116
Reverse Osmosis Plant
For You and Planet Blue.

Advertisement

Table of Contents
loading

Summary of Contents for BWT PERMAQ COMPACT 111

  • Page 1 Installation and Operating manual ® BWT PERMAQ COMPACT 111-116 Reverse Osmosis Plant For You and Planet Blue.
  • Page 3: Table Of Contents

    Layout Drawings ............................21 13.3 Wiring Diagrams ............................25 13.4 Start-up Test ..............................28 13.5 Operating Journal ............................29 13.6 Spare Parts List BWT PERMAQ ® Compact 111-116 ................30 13.7 Spare Parts Drawing ..........................32 13.8 Declaration of Conformity ......................... 33...
  • Page 4: General Information

    Compact plant built together in or- PERMAQ ® tion and operation of the BWT der to take up a little space as pos- Compact plant and PERMAQ ® Compact plant.
  • Page 5: Positioning Of The Plant

    Note! Fit the built-in flowmeter to the cabinet. PLANT The raw water, which is to be Connection of permeate treated in the BWT PERMAQ ® The plant must be placed in a non- (treated water) Compact plant, must be drinking freezing environment on an even Fit the ¾”...
  • Page 6: Start-Up Of The Plant

    3) complete and close the recir- 98 % applies by 75 % recovery. amount at maximum 50-300 l/h culation valve (D-Figure 3). Contact BWT or the supplier of ® for BWT PERMAQ Compact  Now switch on the 230 Volt 50 your plant to decide which outlet 111–116 respectively, at a temp.
  • Page 7: Dearation Of Transport Pump

    Note! The transport pump (G- AUTOMATIC FUNCTIONS capacity is 6 % below the normal 200 l/h, i.e. 188 l/h. At the same Figure 3) will not start until the res- time make sure that the pressure on ervoir tank has been completely PERMAQ ®...
  • Page 8: Maintenance And Trouble-Shooting

    MAINTENANCE AND TROUBLE-SHOOTING Maintenance ® The BWT PERMAQ Compact plant is produced and designed for a minimum of servicing and maintenance. How- ever, there are certain functions which should be checked regularly. Maintenance intervals should be performed once a week – read section 13.5 Operating Journal.
  • Page 9: Trouble-Shooting

    Trouble-shooting This section deals with the problems that may arise on the plant. 9.2.1 The plant capacity has dropped 9.2.2 The quality of the treated water is higher than 20 µS/cm...
  • Page 10: Alarm: Low Raw Water Pressure

    9.2.3 Alarm: Low raw water pressure 9.2.4 Alarm: Transport pump...
  • Page 11: Indication: Level Low

    9.2.5 Indication: Level low 9.2.6 Alarm: Level high...
  • Page 12: The Plant Is Not Operating

    9.2.7 The plant is not operating...
  • Page 13: Alarm: The Transport Pump Stops And Starts

    9.2.8 Alarm: The transport pump stops and starts 9.2.9 Hard water is measured at the soft-water tap...
  • Page 14: 9.2.10 Survey Of Alarm Conditions

    9.2.10 Survey of Alarm Conditions LED function: In normal operation the LED’s are lit corresponding to the components they represent. “Re-start ALARM” on TP-pump: (Nothing is working - permanent Section 9.2.8 condition) ALARM - Too high water level: (Nothing is working - permanent Section 9.2.6 condition) Restore raw water pres-...
  • Page 15: 9.2.11 Settings

    It is possible to change the various time settings for Start, Stop and Alarm, plus start-up delay of pumps. Use of DIP-switch: No. 1 High-pressure pump No. 2 Transport pump ® No. 3 Selection of BWT PERMAQ Compact model Nos. 4-6 Transport pump 10. TECHNICAL SPECIFICATION 10.1 Technical specifications ® BWT PERMAQ...
  • Page 16: Technical Data

    10.2 Technical data BWT PERMAQ ® Compact 111-116 SERIES Capacity, l/h* Maximum recovery, % 40-75 40-75 40-75 40-75 40-75 40-75 Salt retention, % >98 >98 >98 >98 >98 >98 Conductivity, µS/cm <20 <20 <20 <20 <20 <20 Reservoir, l Electrical connection, V...
  • Page 17: Functional Description

    BWT PERMAQ Com- ing, it is recommended to per- high-pressure pump. The desali- pact 111-116 from BWT and fill form the cleaning procedure nated water/permeate is then in 25 litres of warm raw water from the start once more with a led to consumption and can e.g.
  • Page 18: Replacement Of Plant Membranes

    Note! When the hose must be If, after this cleaning, the ca- pacity of the membranes is still pressed hard in to push-in fitting not satisfactory, the membranes until it clicks . must be discarded and new When all connections have been ones must be installed.
  • Page 19: 13. Annex

    13. ANNEX 13.1 P&I diagram 13.2 Layout drawings 13.3 Wiring diagrams 13.4 Start-up test 13.5 Operating journal 13.6 Spare-parts list BWT PERMAQ ® Compact 111-116 13.7 Spare-parts drawing 13.8 Declaration of conformity...
  • Page 20: P&I Diagram

    13.1 P&I Diagram...
  • Page 21: Layout Drawings

    13.2 Layout Drawings...
  • Page 25: Wiring Diagrams

    13.3 Wiring Diagrams...
  • Page 28: Start-Up Test

    NO, the problem does not concerns the plant or the installation The plant - we mean only the part of the whole installation which was delivered by BWT (i.e only the plant). The installation - we mean the piping etc. leading to the plant.
  • Page 29: Operating Journal

    13.5 Operating Journal Maintenance intervals should be performed once a week. Replacement frequency of wearing parts shown in ® section 13.6 Spare Parts List BWT PERMAQ Compact 111-116.
  • Page 30: Compact 111-116

    13.6 Spare Parts List BWT PERMAQ ® Compact 111-116 Recommended Recommended Position No. BWT PERMAQ ® Compact Plant Spare Part No. replacement spare parts frequency Cover Cabinet complete 451202018 Rails on wheels 451202345 Overflow nozzle 405100735 Manifold block 451404690 5" filter housing 321400100 5"-5µ...
  • Page 31 16 µF capacitor (High pressure motor) 321417100 Filter wrench Option Filter housing 10" complete 321401000 Carbon filter 10" 321413000 ½ year Sensor (conductivity meter) 452536000 Conductivity meter 452525000 CIP tank, complete 451404573 * Contact your local BWT dealer for detailed information.
  • Page 32: Spare Parts Drawing

    13.7 Spare Parts Drawing...
  • Page 33: Declaration Of Conformity

    EC Declaration of Conformity for Machinery Directive 2006/42/EC, Annex II, A Low Voltage Directive EMC Directive BWT HOH A/S Geminivej 24 - DK-2670 Greve tel.: +45 43 600 500 - fax: +45 43 600 900 bwt@bwt.dk - www.bwt.dk herewith declares that: BWT PERMAQ ®...
  • Page 34 Notes ________________________________________________________________________________ ________________________________________________________________________________ ________________________________________________________________________________ ________________________________________________________________________________ ________________________________________________________________________________ ________________________________________________________________________________ ________________________________________________________________________________ ________________________________________________________________________________ ________________________________________________________________________________ ________________________________________________________________________________ ________________________________________________________________________________ ________________________________________________________________________________ ________________________________________________________________________________ ________________________________________________________________________________ ________________________________________________________________________________ ________________________________________________________________________________...
  • Page 35 Notes ________________________________________________________________________________ ________________________________________________________________________________ ________________________________________________________________________________ ________________________________________________________________________________ ________________________________________________________________________________ ________________________________________________________________________________ ________________________________________________________________________________ ________________________________________________________________________________ ________________________________________________________________________________ ________________________________________________________________________________ ________________________________________________________________________________ ________________________________________________________________________________ ________________________________________________________________________________ ________________________________________________________________________________ ________________________________________________________________________________ ________________________________________________________________________________...
  • Page 36 Fax: +33 1 4922 45 45 E-Mail: office@bwt.at E-Mail: bwt@bwt.de E-Mail: info@cillichemie.com E-Mail: bwt@bwt.fr BWT Belgium NM. BWE Česká Republika s.r.o. BWT Polska Sp. z o.o. BWT Hungária Kft. Leuvensesteenweg 633 Lipovo 196 -Cestlice ul. Polczyhska 116 Keleti út. 7. B-1930 Zaventem CZ-251 01 Říčany...

Table of Contents