Table of Contents
Advertisement
[INITIALIZE]
Return various setting values to their factory default settings.
1)
Press as to select [INITIALIZE].
2)
Press the <ENTER> button.
f The [SECURITY PASSWORD] screen is displayed.
3)
Enter a security password and press the <ENTER> button.
f The [INITIALIZE] screen is displayed.
4)
Press as to select an item to initialize.
[ALL USER DATA]
[REGISTERED SIGNAL]
[NETWORK/E-MAIL]
[LOGO IMAGE]
5)
Press the <ENTER> button.
6)
When the confirmation screen is displayed, press qw to select [OK], and press the <ENTER> button.
Note
f The security password is the password set in the [SECURITY] menu → [SECURITY PASSWORD CHANGE].
Initial password as the factory default: awsqawsq
f The following settings are not initialized even if [ALL USER DATA] is executed.
g The [PROJECTOR SETUP] menu → [ECO MANAGEMENT] → [STANDBY MODE]
[SERVICE PASSWORD]
This function is used by a service person.
Chapter 4 Settings — [PROJECTOR SETUP] menu
Returns all setting values including [REGISTERED SIGNAL], [NETWORK/E-MAIL], and [LOGO
IMAGE] to the factory default settings.
The projector enters the standby mode to reflect the setting values.
Deletes all the setting values saved for each input signal.
To delete only a part of a registered signal, perform the procedure described in "Deleting the
registered signal" (x page 133).
Returns the various setting values in the [NETWORK/USB] menu to the factory default values.
Deletes the image registered in [USER LOGO].
ENGLISH - 131
Advertisement
Table of Contents
