Operation; Using The Appliance - Miele KMDA 7476 FR Operating And Installation Instructions

Using the appliance

This ceramic glass hob is equipped with
electronic sensor controls which react
to finger contact. For safety reasons, in
order to switch the appliance on, the
On/Off  sensor control needs to be
touched for a little longer than the other
sensors.
Each time a sensor control is activated,
an audible signal sounds.
Only the printed On/Off  symbol is
visible when the hob is switched off.
More sensors light up when the hob is
switched on.
In order to set or alter a power level, the
cooking zones must be "active". To
activate a cooking zone, touch the
display for the relevant cooking zone.
The relevant cooking zone display will
appear brighter when touched. While
the display is brighter, the cooking zone
is "active" and you can set a power
level or time.
Exception: if only one of the cooking
zones is in operation, you can alter the
power level without activating the
cooking zone.

Malfunction due to dirty and/or
covered sensor controls.
If the sensor controls are dirty or
covered this could cause them to fail
to react, to activate a function or
even to switch the appliance off
automatically (see "Safety features",
"Safety switch-off"). Placing hot
pans on the sensor controls/
indicators can damage the electronic
unit underneath.
Keep the sensor controls and
indicators clean.
Do not place anything over the
sensor control or indicators.
Do not place hot pans over the
sensor controls or indicators.

Operation

35