Wall Installation; Telephoning; Making A Call; Redialling - Amplicomms BigTel 40 Plus User Manual

Wall installation

The telephone can also be installed on a wall.
You require two screws in order to fix the telephone on a wall.
Feed the guide tabs (1) on the wall−mounting bracket (2) in the slots (3)
on the rear side of the telephone. Slide the wall bracket (2) 10 mm
upwards until it audibly snaps into place.
P 3
Warning: Ensure that there are no cables or pipes etc. under the
surface of the wall where you want to drill the holes. Make sure that
G
the mounting height is less than 2 meters.
Drill two holes whose distance apart corresponds to the bracket to be
used, insert the screws and allow them to project 5 mm from the wall.
Position the telephone on the bracket, fit the screws in the slots and slide
the telephone downwards a little.
Turn the receiver hook (4) in the receiver cradle 180° so that the receiver
can be hooked in.
4
4
P
3
2
O
N
1
ETTING STARTED
4
4
4
8

Telephoning

Making a call

1. Lift the receiver.
2. Enter the phone number (max. 32 digits).

Redialling

Your telephone stores the last phone number dialled. Lift the receiver and
press .

One-touch dialling

You can use the one-touch dialling buttons for normal direct dialling or as
memory locations for the emergency call function. Be sure to store phone
numbers for one-touch dialling first.
You can insert photos or symbols under the transparent covers of the 6
one-touch dialling buttons to label them.
NOTE: You cannot delete the phone numbers assigned to the one-touch
dialling buttons. The existing phone numbers are overwritten when new
numbers are assigned to them.

Removing the covers from the one-touch dialling buttons

Use your thumb and forenger to grip the cover and remove it, as illustrated
in the diagram. Place the required label or photo under the cover and
replace it on the button.
9