Pin Assignment I/O Connector - IDS NXT rome Technical Manual

7.2 Pin assignment I/O connector

12-pin M12 connector (Attend 216A-12MSR)
Pin Signal
1 VBUS
2 VBUS GND
3 Opto IN (0)
4 Opto IN (1)
5 Opto IN (COM)
6 Opto OUT (COM)
7 Opto OUT (1)
8 Opto OUT (2)
9 RS232 (RxD)
10 RS232 (TxD)
11 Opto IN (2)
12 Opto OUT (0)
Shield Shield
You can check the color assignment of the cable on the
The maximum length of the I/O cable is 30 m. The cable must be shielded.
Power supply
NOTICE! The camera can be supplied with voltage both from an external source and via
Power-over-Ethernet (PoE). The camera should not be supplied through both voltage sources
at once as this can irreparably damage the camera.
Voltage
Current
Residual ripple
IDS Imaging Development Systems GmbH recommends to adjust the power supply to the power requirement
of the camera to limit overheating in case of short circuit.
To ensure the electrical safety, the camera power supply must meet the requirements for SELV (safety extra
low voltage) / LPS (limited power source) or ES1 / PS2. The camera power supply must be rated by the values
given in the table above. It also must ensure that the voltage values given in the table above are available at the
input of the camera.
2021-11-08
Description
Power supply: 12-24 V DC +20 %
Reference level (ground) for power supply and RS-232
Trigger input with optocoupler
Input 1 with optocoupler
Reference level for all Opto IN
Reference level for all Opto OUT
Output 1 with optocoupler
Output 2 with optocoupler
Serial interface
Serial interface
Input 2 with optocoupler
Flash output with optocoupler
Shield
Website
Input I/O connector (M12): 12-24 V DC +20 %
Input GigE connector (RJ45): PoE 41-57 V DC
Input I/O connector (M12): min. 1 A
Input GigE connector (RJ45): min. 350 mA
120 mVpp
IDS NXT: Technical manual IDS NXT rome
directly at the specific accessory item.
Fig. 4: I/O connector,
camera rear view
17