Table of Contents
Advertisement
8 Electrical specifications
·
Pin assignment GigE connector (RJ45)
·
Pin assignment I/O connector
·
Digital input wiring
·
Digital output wiring
·
General Purpose I/O wiring
Exception: PoE may be considered a Network Environment 0 per IEC TR 62101, and thus
the interconnected ITE circuits may be considered SELV, if:
1. the function of the ITE being investigated to IEC 60950-1 is considered not likely to
require connection to an Ethernet network with outside plant routing, including campus
environment; and
2. the installation instructions clearly state that the ITE is to be connected only to PoE
networks without routing to the outside plant.
8.1 Pin assignment GigE connector (RJ45)
8-pin RJ45 socket
Pin
Designation 100BASE-TX
1
Tx+
2
Tx-
3
Rx+
4
5
6
Rx-
7
8
The RJ45 socket of the GigE uEye CP Rev. 2 complies with the IEC 60603-7 standard.
8.2 Pin assignment I/O connector
8-pin Hirose connector (HR25-7TR-8PA(73))
Pin
Description
1
Ground (GND)
2
Flash output
3
General purpose I/O
4
Trigger input
5
Flash output
6
General purpose I/O
7
Trigger input
8
Input power supply (VCC) 12-24 V DC
You can check the color assignment of the cable on the
The maximum length of the I/O cable is 30 m. The cable must be shielded.
January 2020
with optocoupler (-)
(GPIO) 1, 3.1 V
with optocoupler (-)
with optocoupler (+)
(GPIO) 2, 3.1 V
with optocoupler (+)
Technical Manual: GigE uEye CP Rev. 2
Designation 1000BASE-T
Bl_DA+
Bl_DA-
Bl_DB+
Bl_DC+
Bl_DC-
Bl_DB-
Bl_DD+
Bl_DD-
Website
directly at the specific accessory item.
Fig. 5: RJ45
socket, camera
rear view
Fig. 6: Hirose
connector male,
camera rear view
13
Advertisement
Table of Contents
