Programming Mode; Onboard Fdc; Parallel Port - AOpen AP41 User Manual

Programming Mode

The settings for this option are Auto and Manual. The Manual setting
allows you to set up the screen items manually. The Auto setting sets
up all the items automatically except for the Parallel Port Mode
parameter.

Onboard FDC

Enabling this function allows you to use the onboard floppy disk
controller (FDC). The default setting is
Serial Port 1
This parameter allows you to set the base address of serial port 1.
The available settings are 3F8H, 2F8H, 3E8H, 2E8H and Disabled.
3F8H
The default setting is
Serial Port 2
This parameter allows you to set the base address of serial port 2.
The available settings are 3F8H, 2F8H, 3E8H, 2E8H and Disabled.
The default setting is 2F8H

Parallel Port

This parameter allows you to set the base address of the parallel port.
The available settings are 3BCH, 378H, 278H and Disabled. The
default setting is 378H .
User's Guide
AMI BIOS
Enabled .
.
.
3-27