Returning To A Pre-Marked Position - Canon elura10 Instruction Manual

Returning to a Pre-Marked Position

Use the wireless controller to mark a point on a tape that you want to return to
following playback.
MOVIE VCR
P.SCAN
1. Press the ZERO SET MEMORY button on the wireless controller
during playback at a point you want to return to later.
• The time code is replaced by a tape counter that is set to zero with the
indication.
• Press the ZERO SET MEMORY button once more to cancel the zero set
memory.
2. When you have finished playback, fast forward or rewind the tape.
The tape stops automatically when it reaches the zero set position.
• RTN1 or `RTN appears in the display.
• The tape counter with
code reappears.
• The zero set memory may not function correctly where there is a break between
recordings on the tape.
• You can also use zero set memory to mark a position on a tape in camera mode.
When you then play back the tape, pressing rewind will take you back to the
pre-marked position.
• If you remove the tape while the zero set memory is set, the memory is
canceled and the tape counter reverts to time code.
• The camera remembers your setting even if you turn it off and back on again or
move the program selector.
indication disappears from the display and the time
ZERO SET
SEARCH
SELECT
MEMORY
AUDIO
REW FF
PLAY
DUB.
A/V
STOP
– / + /
INSERT
× 2
PAUSE SLOW
REMOTE
E
79