Table of Contents
Advertisement
10. AUTO-OFF
The time can be changed so that the appliance switches off after
being idle for 15 or 30 minutes, or after 1, 2 or 3 hours.
To re-set Auto-off, proceed as follows:
1. With the appliance off (standby), but the main switch
(A15) pressed (fig. 4).
2. Press and hold the icon
icons on the touch screen (B) come on.
3. Press the icon
(B13) to select the required time:
4. Press the
icon (B12) to confirm (or
exit without making the modification). The lights/icons go
off.
The auto-off time is now programmed.
11. ENERGY SAVING
Use this function to enable or disable energy saving. This mode
is active by default, reducing energy consumption while the ma-
chine is on in compliance with current European regulations. To
change the setting, proceed as follows:
1. With the appliance off (standby), but the main switch
(A15) pressed (fig. 4).
2. Press and hold the icon
light
(B3) (if energy saving is enabled) come on.
3. Press the icon
again to enable (the light
disable (the
light goes off) energy saving.
4. Press the
icon (B12) to confirm (or
without making the modification). The lights/icons go off.
The energy saving setting is now programmed.
Please note:
•
When in energy saving mode, a few seconds may elapse
before the first coffee is delivered as the appliance must
heat up again.
12. DEFAULT VALUES (RESET)
This function resets all settings (temperature, auto-off, water hard-
ness, energy saving and all quantity settings are reset to the default
values).
1. With the appliance off (standby), but the main switch
(A15) pressed (fig. 4).
(B8) until the lights and
15 min.
30 min.
1 hour
2 hours
3 hours
(B10) to
(B13) until the icons and
-B3) or
(B10) to exit
2. Press and hold the icon
touch screen (B) come on.
3. Press the icon
(B10) to exit without making the modification). The
icons go off.
The settings and quantities have been reset to the default
values.
13. MAKING COFFEE
13.1 Selecting the coffee taste
Turn the coffee taste selection dial (B9) to set the required taste.
Turning it clockwise increases the quantity of coffee beans the
appliance will grind and therefore the strength of the coffee ob-
tained. Turn the dial to MIN for an extra mild coffee and to MAX
for an extra strong coffee.
Please note :
•
The first time you use the appliance, you will need to make
a number of coffees to identify the correct dial position
through trial and error.
•
Do not turn the dial too far towards MAX, otherwise the
coffee may be delivered too slowly (a drop at a time), par-
ticularly when making two cups of coffee at the same time.
13.2 Selecting the quantity of coffee in the cup
The appliance is set by default to automatically make the fol-
lowing quantities of coffee:
coffee requested
icon
1 short coffee
1 long coffee
2 short coffees
2 long coffees
To change the quantity of coffee the appliance delivers automa-
tically into the cup, proceed as described below:
-
press and hold the icon
pending on the quantity you want to modify) until the icon
flashes and all the alarm lights flash 4 times. When the
appliance starts delivering coffee, release the icon;
-
when the coffee in the cup reaches the required level, press
the same icon again to memorise the new amount.
When the icon is pressed again, the new quantities have been
memorised.
11
(B15) until the icons on the
(B12) to reset the default values (or
quantity delivered
(≃40ml)
(≃120ml)
(≃40ml) x2
(≃120ml) x2
(B2) or
icon (B11) (de-
Advertisement
Table of Contents
Troubleshooting
