GB GAME RIDER BGB7200 Manual page 13

A s s e m b l y S t e p 9
A.Please ensure that the cables connected to the Bike Monitor (#43) are within the track of the backside so they do not get
pinchedor damaged during this next process (please see diagram). Slide the track of the Bike Monitor (#43) halfway onto
the Monitor Support Bracket (#06)
then slide the Bike Monitor (#43) onto the rest of the track until the monitor locks in place.
Please note: if you need to remove the Bike Monitor (#43) , press and hold down the tab on the back of the Bike Monitor (#43)
to unlock, slide, then release the tab.
B.Now, connect the corresponding cables as shown in diagram No. 7:
- 43a to 47
-Please connect designated wires to matching numbers (i.e. "1" to "1"; "2" to "2").
}
- 43b to 48
- 43c to 45a
NOTE: Wires do not require excessive force to connect; please use care when connecting.
- 43d to 46
C.Then, carefully place and tuck all the connected cables into Hole B as shown in diagram No. 8.
Please note: 1.) there is room for you to tuck the cables upward and downward in the hollow area of the Center Post (#04)
2.) use care when tucking in cables to avoid injury to your fingers and hands
BGB 7200
Assembly Instructions
,
tuck the Wires (#43a/b/c/d) on the Bike Monitor (#43) through Hole A (diagram No. 6),
Page 11