Table of Contents
Advertisement
A s s e m b l y S t e p 8
Align the holes of the Monitor Support Bracket
(#06) with the holes on the Center Post (#04) as
shown in the diagram. Please ensure that the
wires are free and clear from the bracket. Then,
secure the Monitor Support Bracket (#06) using
two Screws (#26 ).
Wires will fall freely in this step.
You do not and should not need to feed wires
through the Monitor Support Bracket (#26).
#42 WASHER FOR M10 BOLT,T2.0 1PC
#42 WASHER FOR M10 BOLT,T2.0 1PC
BGB 7200
Assembly Instructions
#42 WASHER FOR M10 BOLT,T2.0 1PC
Hardware & Tool Required
Bolt
#26 Screw (M5x16 mm) [2 Pieces]
Tool
Page 10
Advertisement
Table of Contents
