Selection Overview - Matrix SDT 5000 User Manual

SDT 5000 User Manual
<UP ARROW>

10.3 Selection Overview

Commands and Selection Numbers (called commands for the rest of this section) are issued from
the Select Field. The entry of a command into the Select Field is case insensitive, so the user
doesn't need to worry about capitalization of particular words. The following commands are
common to most screens in the system, but some screens have screen specific commands. (Please
see the specific screens for more details).
DEFAULTS
DISCONNECT
EXIT
NEXT
PREV
SAVE
UNDO
The Select Field will recognize portions of commands as being unique. This means instead of
typing EXIT <ENTER> to leave a screen you need only type <e> <ENTER>.
A screen that has had edit field values changed will not let the user leave until the changes are
either saved or undone.
Version 1.1, 03/24/06
While in numeric Edit Fields the current value of the field is
incremented by one. While in enumerated fields with
predefined values, advance to the next value.
Resets all edit fields on the screen to their default values.
Only available from the "Logon" screen, this is used to blank
the screen after configuring the unit. If the unit is in standby,
it will also power-down after a configurable time (default 300
seconds).
Exit the current screen to the previous screen.
This will vary from screen to screen. Please refer to the
screen reference.
This will vary from screen to screen. Please refer to the
screen reference.
Save all the new values on the screen into the parameters the
Edit Fields represent. Any actions that these changes imply
will also be executed.
Will undo any changes to edit fields. If no SAVE has been
performed, this command will restore the original values. If
SAVE is executed first the original values will be lost.
Document MBUD-0109v11
Page 51