Alpine INE-W960HDMI Owner's Manual page 93

In-dash gps navigation receiver
Table of Contents

Advertisement

Radio Antenna Receptacle
Video Output Connector (AUX OUTPUT) (Yellow)
SiriusXM Tuner Input Connector (INE-W960/INE-NAV-
60 only)
Rear Output RCA Connectors
It can be used as Rear Output RCA Connectors. RED is
right and WHITE is left.
Front Output RCA Connectors
It can be used as Front Output RCA Connectors. RED is
right and WHITE is left.
Subwoofer RCA Connectors
RED is right and WHITE is left.
CAMERA Input RCA Connector (Yellow)
Use when connecting a camera with RCA Output
Connector.
Remote Control Output Lead (Brown)
Connect this lead to the remote control input lead. This lead
outputs the controlling signals from the remote control.
iPod VIDEO Input Connector
Input the iPod/ iPhone video signal or AUX video/audio
signal.
• Set "AUX In" (page 44) to "iPod Video" when an iPod/iPhone
is connected.
• Set "AUX In" (page 44) to "AUX" when AUX video/audio is
input.
USB Connector
To USB Memory or iPod/iPhone.
MIC Input Connector
To Microphone (Included).
Steering Remote Control Interface Connector
To steering remote control interface box.
For details about connections, consult your nearest Alpine
dealer.
AUX/PRE OUT Connector
Power Supply Connector
REMO (Remote Turn-On) Lead (Blue/White)
Connect this lead to the remote turn-on lead of your
amplifier or signal processor.
Reverse Lead (Orange/White)
Connect to the plus side of the car's reverse lamp. This
lamp illuminates when the transmission is shifted into
reverse (R).
With this lead properly wired, the video picture
automatically switches to the rear camera whenever the car
is put into reverse (R).
P.ANT (Power Antenna) Lead (Blue)
Connect this lead to the +B terminal of your power antenna,
if applicable.
• This lead should be used only for controlling the vehicle's
power antenna. Do not use this lead to turn on an amplifier or a
signal processor, etc.
Parking Brake Lead (Yellow/Blue)
Connect this lead to the power supply side of the parking
brake switch to transmit the parking brake status signals to
the INE-W960/INE-NAV-60/INE-W960S.
GPS antenna Receptacle
To GPS antenna (included).
ACC (IGNITION) Lead (Red)
Connect this lead to an open terminal on the vehicle's fuse
box or another unused power source which provides (+)
12V only when the ignition is turned on or in the accessory
position.
BATT (BATTERY) Lead (Yellow)
Connect this lead to the positive (+) post of the vehicle's
battery.
Fuse Holder (15A)
Ground Lead (Black)
Connect this lead to a good chassis ground on the vehicle.
Make sure the connection is made to bare metal and is
securely fastened using the sheet metal screw provided.
Left Rear (+) Speaker Output Lead (Green)
Left Rear (–) Speaker Output Lead (Green/Black)
Left Front (+) Speaker Output Lead (White)
Left Front (–) Speaker Output Lead (White/Black)
Right Front (–) Speaker Output Lead (Gray/Black)
Right Front (+) Speaker Output Lead (Gray)
Right Rear (–) Speaker Output Lead (Violet/Black)
Right Rear (+) Speaker Output Lead (Violet)
93
-EN

Advertisement

Table of Contents
loading

This manual is also suitable for:

Ine-nav-60hdmiIne-w960shdmi

Table of Contents