Adjusting Brightness; Adjusting Color Of Picture; Adjusting Image Contrast; About Ine-W960/Ine-Nav-60/Ine-W960S - Alpine INE-W960HDMI Owner's Manual

Adjusting Brightness

Setting item: Brightness
Setting content: -15 to +15 (Initial setting: 0)
You can adjust the brightness between MIN (-15) and MAX
(+15). When it reaches the minimum or maximum point, the
display shows "MIN" or "MAX" respectively.

Adjusting Color of Picture

Setting item: Color
Setting content: -15 to +15 (Initial setting: 0)
You can adjust the color between MIN (-15) and MAX (+15).
When it reaches the minimum or maximum point, the display
shows "MIN" or "MAX" respectively.

Adjusting Image Contrast

Setting item: Contrast
Setting content: -15 to +15 (Initial setting: 0)
You can adjust the contrast between LOW (-15) and HIGH (+15).
When it reaches the minimum or maximum point, the display
shows "LOW" or "HIGH" respectively.

About INE-W960/INE-NAV-60/INE-W960S

[About] is selected on the General setup menu in step 3. Refer to
"General Setup Operation" (page 30).

Displaying the Product Information

You can view the version information of this product. Make note of this
information and refer to it whenever you contact Alpine Tech Support or
an Alpine-authorized dealer.
Setting item: Version Info
Setting content: Serial No. / Firmware Version
®
Checking the DivX
This unit will display the registration code required to play a DivX
VOD (Video On Demand), or you can also display the deregistration
code.
Setting item: Warranty/Copyright Info.
Displaying the Registration Code
1
Touch [Warranty/Copyright Info.].
2
Touch [DivX(R) VOD].
3
Touch [Registration].
The registration code is displayed on the screen.
4
Touch [OK].
Displaying the Deregistration Code
1
Touch [Warranty/Copyright Info.].
2
Touch [DivX(R) VOD].
3
Touch [Deregistration].
The confirmation dialog screen appears.
4
Touch [OK].
The deregistration code is displayed on the screen.
• When you have finished, touch [Cancel]. If you want to continue and
display a new registration code, touch [OK], check the registration
code, and then touch [OK] again.

Initializing the System

You can initialize all data, to restore the factory settings. Remove the
CD/DVD disc, etc. from the system before operation
Setting item: Restore Factory Setting
1
Touch [Restore Factory Setting].
2
After the confirmation message appears, touch
[OK].
The confirmation screen appears again.
3
Touch [OK].
The system starts initialization.
• Do not turn on/off the power or change the ignition key position until
system restart is completed.
Registration
33
-EN
®