Table of Contents
Advertisement
Adjusting guides simultaneously (for Rear camera only)
Touch [Link].
The 3 vertical guides of the currently-selected guide link
together, allowing them to be adjusted simultaneously.
Turning guide display On/Off
Turning the selected guide off.
1
Touch [On/Off].
The currently selected guide will turn off.
2
To turn the guide on, touch [On/Off] again.
• Guides that are turned off are still adjustable.
Returning guides to default
1
Touch [Default].
A message window will appear.
2
Touch [OK].
Adjusted values will return to default settings.
Guide Display On/Off Setting
1
Touch [Guide Off] on the Rear camera display
screen.
The guide disappears, and then the [Guide Off] switch
changes to [Guide On].
2
Touch [Guide On] to turn on the guide.
Adjusting the Caution Display Location
Touch [Caution].
• For each touch, the caution location moves to the top or bottom of the
screen.
Camera Interrupt Setting (Power OFF
Mode)
[Camera Interrupt] is selected on the Camera setup menu in step 3.
Refer to "Camera Setup Operation" (page 49).
You can set whether to display the rear camera image when the gear
lever is moved to the reverse (R) position while the unit is power off.
Setting item: Camera Interrupt (Power OFF Mode)
Setting contents: On / Off (Initial setting)
On:
The rear camera image is displayed
Off:
The rear camera image is not displayed
50
-EN
About the Rear Camera Guide
To display the guide, set "Guide Display On/Off Setting" (page 50) to
On. Also, to adjust the guide, refer to "Adjusting the Rear Camera
Guide" (page 49). You can also turn off the guide in the Rear camera
display screen.
Indication mark meaning
When the car is put into reverse gear, the monitor switches to the rear
view camera image. Guides appear to help visualize the car's width and
distance from the rear bumper.
1 Car width extension marks (red, yellow and green in
order of distance)
If properly calibrated, the marks indicate the car's width.
This helps guide the car's path when backing up in a
straight line.
The marks represent the distance from the rear of the car
(from the rear end of the bumper).
• The marks do not move in synchronization with the
steering wheel.
• Set the marks to suit the car's width.
2 Distance guidance marks
The marks represent the distance from the rear of the car
(from the rear end of the bumper).
• The marks do not move in synchronization with the
steering wheel.
• We recommend that you measure the actual distance to
the marks when parked on a level surface.
• Depending on the condition of the car or road surface, the range of
vision may vary.
• The camera has a limited range of vision. Objects at extreme angles
to the camera (e.g. under the bumper or at opposite ends of the
bumper) may not be in the its field-of-vision.
• The rear camera image may have a tint which is different from the
actual surroundings.
• Depending on the car, the guidance may deviate to the right or left.
This is not a malfunction.
Distance guidance mark
The distance guides represent the ground level distance from the rear
bumper. It is difficult to accurately estimate the distance to objects
above ground level.
In the following example, the distance to A is 0.5 m and the distance to
B is 1 m.
Advertisement
Table of Contents
