Return The Damaged/Defective Item To Keysight For Repair/Replacement; Step 2 - Set Up The M8100A; Step 3 - Set Up The External Host Computer (Not Required For M8100A-Bu6) - Keysight Technologies M8100A Series Getting Started Manual

Return the Damaged/Defective Item to Keysight for Repair/Replacement

Step 2 - Set up the M8100A

Step 3 - Set up the External Host Computer (not required for M8100A-BU6)

Keysight M8100A Series Arbitrary Waveform Generators Getting Started Guide
If anything is missing, defective, or damaged,
1 Review the warranty information shipped with your product or check
the warranty information on Keysight website.
• To check the warranty information on your module, go to
www.keysight.com/find/warranty
number (for example, M8199A) in the Product Number field, and
specify the serial number from the top of the module in the Serial
Number field.
2 Contact the nearest Keysight Sales Office. If you need assistance
finding Keysight contact information, go to
www.keysight.com/find/assist
repair and service).
This step does not have to be performed while verifying the basic setup
for power up and connectivity. However, you will need to decide on a
benchtop or rack mounted usage of the M8100A after this basic
verification. For the procedures on how to set up the M8100A, refer to
the M8000 Series Installation Guide.
Perform this step if you are using a laptop or desktop computer as the
NOTE
host computer.
The host computer communicates with the ESM and instrument modules
in the chassis and hosts all the software components needed to use the
instrument modules.
Basic Setup for M8100A
and specify the module's model
(worldwide contact information for
2
27