Table of Contents
Advertisement
SYSTEM MENU
FAeq: Dimming Frequency.
Select "FAeq," then press the ENTER button. Use the DOWN and UP buttons to scroll through the
available frequency settings (900 Hz, 1000 Hz, 1100 Hz, 1200 Hz, 1300 Hz, 1400 Hz, 1500 Hz, 2500
Hz, 4000 Hz, 5000 Hz, 10000 Hz, 15000 Hz, 20000 Hz, or 25000 Hz). Press ENTER to confirm your
selection, or press MENU to exit without making changes.
gANN: Gamma Correction.
Select "gANN," and press the ENTER button. Use the DOWN and UP buttons to scross through the
available gamma correction settings (No, 2.0, 2.2, 2.4, 2.6, or 2.8). Press ENTER to confirm your
selection, or press MENU to exit without making changes. Please note that the 2.6 gamma cor-
rection setting was added with software update version 1.3.
dISP: Display Invert.
Select "dISP," and press the ENTER button. Use the DOWN and UP buttons to scroll between
"dISP" (normal orientation) or "dSIP" (inverted orientation). Press ENTER to confirm your selection,
or press MENU to exit without making changes.
NAnd: Manual Mode.
Select "NAnd," and press the ENTER button. Use the DOWN and UP buttons to select the bright-
ness (dxxx) or strobe (Sxxx). Please note that strobe is only available when the device is set to
4-Channel Mode or 6-Channel Mode. Press ENTER to confirm your selection, then use the DOWN
and UP buttons to adjust the value between 000 - 255. Press ENTER again to confirm your selec-
tion, or press MENU to exit without making changes.
teSt: Auto Test.
Select "teSt," and press the ENTER button. The unit will now run a built-in self-test program. Press
the MENU button to return to the main menu, or wait ten seconds for the system to automatically
return to the main menu.
tENP: Temperature Display.
Select "tENP," and press the ENTER button. The device will now display the current temperature
reading of the device. Press MENU to return to the main menu.
FhrS: Fixture Hours.
Select "FhrS," and press the ENTER button. The device will now display the number of run time
hours that have been logged. Press MENU to return to the main menu.
ver: Software Version.
Select "ver," and press the ENTER button. The device will now display the current software version
of the unit. Press the MENU button to return to the main menu.
dEF: Factory Setting.
Select "dEF," and press the ENTER button. Use the DOWN and UP button to scroll to either "YeS" to
restore the device to factory settings, or "no" to exit without making changes. Press the ENTER but-
ton to confirm your selection.
20
Advertisement
Table of Contents
