Advertisement
do not lift the appliance by the door
handle.
Whilst every care is taken to elimi-
nate burrs and raw edges from this
product,please take care when handling -
we recommend the use of protective
gloves during installation.
please note that the weight of this
appliance is approximately 45kg
(unpacked). Take care when lifting it into
the housing unit - always use an
appropriate method of lifting.
Leave the fixing screws in the base tray
packaging until you are ready to install it.
If this appliance is to be installed near to
a corner where the adjacent cabinets run
at right angles forward of the appliance,
there must be a gap of at least 90 mm
between the appliance and the cabinets,
to prevent overheating of the cabinets.
installation
24
Housing dimensions
The appliance is designed to fit into a
standard 600mm wide housing unit with
minimum internal dimensions as shown.
590mm is to the underside of the worktop
when the appliance is built under, or to
the underside of the panel above, when
the appliance is installed into a tall
housing unit.
Advertisement
