Table of Contents
Advertisement
High Frequency Measurements with 10:1 Probe
Fluke recommends the VP41 10:1 Probe to measure high
frequency signals in circuits with high impedance. The
loading of the circuit by a 10:1 Probe is much lower than
that of a 1:1 Shielded Test Lead.
Probe attenuation and probe adjustment must be
observed when using a 10:1 Probe.
Probe Attenuation
The Probe attenuates the signal 10X. The example below
is for a Probe connected to input A.
To adapt the Test Tool's voltage readout to this
attenuation:
1.
Push to open the Scope and Meter button bar.
2.
Push 3 to open the INPUT SETTINGS menu.
YZ
3.
Use
4.
Push to open the PROBE SELECT menu.
YZ
5.
Use
6.
Push to make the change.
Observe that the 10X attenuation of the Probe is
compensated in the voltage readout.
sales@GlobalTestSupply.com
to go to Select>.
to highlight 10:1 V.
Fluke-Direct
Power and Harmonics Mode
Probe Adjustment
The VP41 Probe is always adapted correctly to its inputs.
High frequency adjustment is not necessary.
Other 10:1 Probes however must be adjusted for optimal
High Frequency performance. See 10:1 Scope Probes for
information about how to adjust these Probes.
Power and Harmonics Mode
The Power and Harmonics mode offers:
• Single phase power measurements with waveform and
harmonics display
• Voltage RMS, Current RMS, frequency, and phase
measurements
• Active, apparent, and reactive power measurements
• Power factor, cos ϕ, and total harmonic distortion
measurements
This section is a step-by-step introduction to power and
harmonics measurements. It does not cover all of the
capabilities of the Test Tool but gives basic examples to
show how to use the menus and perform basic
operations.
To use the power and harmonics functions, connect the
voltage leads and current probe as shown in Figure 7
setup 2.
.com
Industrial ScopeMeter®
35
1.888.610.7664
Advertisement
Table of Contents
