Table of Contents
Advertisement
Waveform Acquisition
The Test Tool can be setup to acquire waveforms as
needed for a specific application. This section explains
the setup options.
Single Acquisition
To catch single events, you can perform a single shot
(one time screen update).
To set up the Test Tool for a single shot on the input A
waveform:
1.
Connect the probe to the signal to be measured.
2.
Push to open the Scope and Meter button bar.
3.
Push 2 to open the SCOPE SETTINGS menu.
YZ
4.
Use
5.
Push to make the change.
6.
Push 4 to exit the menu.
The Test Tool will now show the acquisition screen
and the Information area updates:
Waiting
Run
Hold
sales@GlobalTestSupply.com
to highlight the Update as Single.
Test Tool is waiting for a trigger
single acquisition is triggered
single acquisition is complete
Fluke-Direct
To continue with the next single acquisition:
7.
Push and wait for another single acquisition
trigger.
.com
Industrial ScopeMeter®
Scope and Meter Mode
hxv19.eps
27
1.888.610.7664
Advertisement
Table of Contents
