Table of Contents
Advertisement
7.2.10. Floor nozzle pipe unit
1. Remove the temperature sensor (Nozzle motor unit).
2. Remove the Floor nozzle pipe unit connector from the
P.C.B E unit.
3. Remove the securing screw (1 screw) and remove the
Floor nozzle center.
■Caution
• When removing connectors, pull them straight out. If they
are pried out, it may cause a break or poor contact of the
lead wire.
• When removing the Floor nozzle center, be careful that
thlider and Switch slider spring within do not spring out
and become lost.
• The Floor nozzle center can be easily removed by insert-
ing a flathead screwdriver into the ribbed part within the
floor nozzle and prying it open.
47
Advertisement
Table of Contents
