Table of Contents
Advertisement
■Caution
• Do not force the P.C.B holder A unit when removing it
from the body A unit. There is a risk that lead wires, con-
nectors, etc. may become broken or deformed.
• The P.C.B holder A unit can be easily taken out if the
lead wires are fed through as shown in the diagram.
3. Open up the insulation plate.
*One side is secured.
4. Disconnect the connectors and faston terminals from the
P.C.B A unit (2 points).
• Insertion
When fitting together the connector on the main unit end
(female end) and the tab (male end), hold the connector
and push it directly onto the tab. If the connector is
pushed on from an angle or is pushed on while being
twisted, it may cause deformities or poor connection.
• Removal
When removing the connector from the tab, pull it
straight off. When removing it, do not pry it out. Doing so
may cause deformities.
5. Remove the lead wires of the P.C.B B unit and P.C.B K
unit from the body A unit and remove the P.C.B holder A
unit.
41
Advertisement
Table of Contents
