Panasonic MC-BJ870-S149 Service Manual page 46

7.2.6. Floor nozzle pad left
1. Insert a flathead screwdriver into the place indicated with
the arrows on the diagram and remove the Floor nozzle
pad left from the Floor nozzle lower unit.
■Caution
• When removing the Floor nozzle pad left, be careful that
the Spring B within does not spring out and become lost.
If the Spring B falls out of place, place it back as shown
in the diagram.
• Be careful not to mix up Spring B and Spring D when set-
ting the springs. If left and right are mixed up, it will not
function properly.
7.2.7. Partition complete
1. Pull up the Partition complete to remove it.
7.2.8. Bumpers (left/right)
1. Remove the Bumpers (left and right).
7.2.9. Nozzle motor unit
1. Remove the Nozzle motor unit connector from the P.C.B
E unit.
■Caution
• When removing connectors, pull them straight out. If they
are pried out, it may cause a break or poor contact of the
lead wire.
2. Remove the Nozzle motor unit.
46